Geek Freely: ion

    Featured Post

    The whole point in this post is to run your own VPN service, and allow you to connect remote devices to your home network.

    To start off yo…

    Showing posts with label ion.

    Showing posts with label ion.

    The Hardware

    After approximately 10 years of using XBMC, the old name for Kodi, I have tried a variety of hardware end-points.

    Always searching for the best bang for my buck. My conclusion is the Chromebox, I have a single

    and I am considering replacing my Pi’s with two more Chromeboxes. Raspberry Pi’s are nice and all, but they just don’t have the grunt, you are constantly modifying settings and over-clocking. The Asus Chromebox is a no hassle Kodi player.

    It’s silent, powerful, and it comes at the great price ~$160.

    Now I know a lot of people will be saying the Pi is cheaper, but let’s be honest – you need to spend at least $95. For that you get, the

    (~$45),

    (~$10),

    (~$10),

    (~$15) – and that doesn’t even include cables or a power supply, because you may have it lying around.

    The only question about the Chromebox is to consider which version. Some will , and some will give you , and of course some will give you both.  I have a basic , but am tempted by the

    for the AC network adapter.  provided some insightful comments on the Chromebox support of 4k and Wireless AC. AC network support can be gained in the cheaper Asus box with the , and there appears to be no difference in 4k support between models, however I had previously read the i5 would be required for 4k.

    Update: Some other readers noticed hardware omissions, I’d love to hear feedback on other hardware users have had success with, but a comparison always helps.  Here are a few I would love some more performance comparisons on:

    The Software

    There are a bunch of approaches, with the only real restriction being the hardware your running it on. I have tried the following:

    If you have ever read any of my , it will be no surprise that OpenELEC is the clear winner for me.

    The Remote

    For me this was a simple decision, nothing fancy here – I have tried a variety of solutions.

    At this time I am using the USB receiver from a

    and USB IR receiver I purchased for my initial XBMC HTPC, I have programmed my to send MCE commands – and that’s it. You could also use and have IR commands converted to keyboard commands – which gives you a lot of flexibility (I used to have a remote button programmed to send “w”, to update watched status quickly.)

    Update: One attentive reader, , noted the omission of . Utilizing the CEC adapter leverages your current TV remote to take care of the basic HTPC functionality. I personally find I want a few more buttons, but if you need the basics this is certainly worth investigating.

    The Installation and Configuration

    So you have your hardware and software, all you need to do now is install the software and you are ready to enjoy your music and home movies!

    I created a

    some time ago based on several different sources, but  has an

    that is a much better resource than my dated post.

    provides a simple installation script for running, after you have prepared the hardware, and the guide also recommends settings and covers some known issues.

    The Extras

    Personally, since I run three of these boxes in my house I like to have a synchronized library, providing watched/un-watched/resume status throughout the house. . Kodi is certainly moving towards a shared library implementation using UPNP – but I’m not sure it is quite there yet.

    So I have about 3 machines in my house that function as HTPCs.  One of those systems I use with full blown blown Ubuntu and XBMC install from repo.  The other systems I use , I have this installed on an old NVIDIA ION system and a Rasberry Pi.

    I have also advised two systems, which I setup, to use Openelec.  which has a great price on it, I can only assume due to the fact that they are coming out with a new version…which !

    Some of the main benefits about openelec.

    The main reason I am not using this on my main media center is due to the lack of support installing .  This main system is used to serve my streaming music to web and mobile apps, therefore, until I have played about with installing Subsonic on NAS4Free or Openelec, I will stick with an Ubuntu system in my household.

    Some other options:

    Well I upgraded to XBMC 9.11 alpha 2.

    So far I haven’t seen any significant reasons to push this update, in fact I see issues to stay where you are.

    1. Lirc is a nightmare to get configured for remotes – and I lost all my settings!

    2. There seems to be some visual defects in the video playback – which I haven’t had the chance to look into.

    Anyway, I like to try the latest in case there is something I don’t want to miss. I decided to ge rid of XBMC Live on my ION HD HTPC, since it had changed to read only, so no settings were saved.

    I read somewhere that someone else had this issue – it was caused from changing from VGA to HDMI – physical outputs, not settings – weird huh?!

    I did an overall clean house on both my HTPCs, installed the latest Ubuntu and reinstalled XBMC.

    Apart from the remote and video issues I am really happy – nice spring clean – or should I say fall.

    I urge you to check out XBMC if you are looking for a home media playback device.

    It’s cheap and will play anything you throw at it.

    Plus with the scraping tools it is a good way to keep all media organized… And I stream mine from FreeNAS – more on that later though.

    Subscribe to:

    Labels

    Blog Archive

    Links

    Leave a Reply

    Your email address will not be published.